The 971100-3 Solartron DP/2/S Spring Digital Probe, 2mm Range is on sale at Gaging.com. We are authorized Solartron dealers.
Contact us for special pricing!

*Shipments orginate from the Solartron/Ametek factory in England. A $40 handling fee for Solarton orders under $2500 will be applied.

Extremely Repeatable
Precise/Reliable
Ideal for high volume measurements
Tougher than linear encoders
Ease of setup/connectivity
No calibration needed - Analog probes must be calibrated with electronics
Can be mastered or “zeroed” anywhere across measurement range– Analog probes must often be mastered around the “null point”
Multiple interface options
Affordable

Performance

Measurement Range	2 mm
Accuracy (% of Reading) (Note 1)	0.05%
Accuracy (% of Reading) (Note 1) - with In line Connector	0.2%
Repeatability (worst case) (Note 2)	0.15 μm
Repeatability (typical) μm (Note 3)	0.05 μm
Resolution	0.01 μm
Pre Travel	0.15 mm
Post Travel	0.85 mm
Tip Force (N) at Middle of Range ±20%, Spring Push	.07 N
Temperature Coefficient %FS	0.01 ºC

Note 1: Accuracy 0.1 μm or % reading whichever greater
Note 2: Repeated operation against a carbide target with side load applied to the bearing using max-min
Note 3: Repeated operation against a carbide target standard deviation from average (68%)

Environmental

Sealing for Probe	IP65 with gaiter / IP50 without
Sealing for Probe Interface Electronics	IP43 for module and TCON
Storage Temperature (ºC)	-20 to +80
Probe Operating Temperature with Gaiter (ºC)	+5 to +80
Probe Operating Temperature without Gaiter (ºC)	-10 to +80
Electronics Operating Temperature (ºC)	0 to 60
EMC Emissions	EN61000-6-3
EMC Immunity	EN61000-6-2
Probe Life	100 million cycles (no side load), > 10 million cycles in most applications

Material

Probe Body	Stainless Steel
Probe Tip (options)	Nylon, Ruby, Silicon Nitride, Tungsten Carbide
Gaiter (Note 6)	Fluoroelastomer or Silicon
Cable	PUR
Electronics Module	ABS